Data Connect V.3600UI Instrukcja Użytkownika Strona 1

Data Connect V.3600UI modem User Manual V1.7 07008-00027 2004/11/15

CHAPTER 1： MODEM INTRODUCTION Table 1-1B : V.34 Symbol Rate and Carrier Frequency Symbol Rate (Baud) Low Carrier (Hz) High Carrier (Hz) 2400 1600

CHAPTER 1： MODEM INTRODUCTION • Far-end Echo Coverage : Maximum 1.2 seconds. • Scrambler & Descrambler : Comply with ITU-T V.34,V.32bis,V.32

CHAPTER 1： MODEM INTRODUCTION 7

CHAPTER 2: INSTALLATION CHAPTER 2INSTALLATION 2.1 Description 2.2 Unpacking 2.3 Site Requirements 2.4 Site Selection 2.5 AC Electrical

CHAPTER 2: INSTALLATION CHAPTER 2: INSTALLATION 2.1 Description This chapter provides the information needed to install the Network Series Modem and

CHAPTER 2: INSTALLATION 2) If you are unsure whether the electrical service in your building is properly grounded, have it examined by your municipal

CHAPTER 2: INSTALLATION 2.6 Connecting With Dial Line To connect your modem to a permissive RJ11 voice jack and dial line, follow this procedure: On

CHAPTER 2: INSTALLATION 2.7 Connecting With Leased Line For the leased line connection, you should connect the lines RJ45 connector labeled with &qu

Contents CHAPTER 1： MODEM INTRODUCTION...2 1.1 Description ...

CHAPTER 3 : FRONT PANEL AND MENU TREE CHAPTER3FRONT PANEL AND MENU TREE 3.1 The Front Panel Description 3.2 The Rear Panel Description 3.

CHAPTER 3 : FRONT PANEL AND MENU TREE CHAPTER 3 : FRONT PANEL AND MENU TREE 3.1 The Front Panel Description There are 5 key on the front panel of M

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.3 Operating the Network Series Modem 1. Key : Total 5 keys, as follow: VO/DA It is used as the voice/d

CHAPTER 3 : FRONT PANEL AND MENU TREE B. Menu Select Exp 1 : Exp 2 : L MENU Select STATUS L MENU Select TEST Description: 1) In top

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.4 The Menu Tree Main Menu REMOTE STATUSSTATUSVersionTopDIALPROTOCOLTESTCONFIG MODEMCONFIG DTECOMMANDLINE S

CHAPTER 3 : FRONT PANEL AND MENU TREE B. DIAL MENU Dial a Number #0 nnnn\#1 nnnn\...\#9 nnnn Edit a Number #0 nnnn\#1 nnnn\...\#9

CHAPTER 3 : FRONT PANEL AND MENU TREE ORG/ANS Mode Answer Mode\Originate Mode Auto Retrain On\Off Tx Clock Internal\External\Loopback

CHAPTER 3 : FRONT PANEL AND MENU TREE H. LINE SETUP MENU Line Type Dial \2W Leased Line\4W Leased Line Leased To Dial Manual\Auto Back

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5 Detailed Description of the Menu Tree 3.5.1 STATUS MENU Item Name Command Description TX LEVEL = -XX dB

CHAPTER 3 : FRONT PANEL AND MENU TREE MANU RETRAIN ATO2 Force Modem redo adapting. RX BAUD = XXXX AT%S Indication of the signaling rate of r

(‘+’+<char>):...44 4.17.3 Additional Informatio

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5.2 DIAL MENU Item Name Command Description Dial a Number \#0...#9 ATDSn Dial out a preset telephone num

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5.3 PROTOCOL MENU Item Name Command Description Protocol Type AT\Nn Select error correction and data com

CHAPTER 3 : FRONT PANEL AND MENU TREE password. Time required for sending password is about 2 seconds; Control code ‘+’ can be applied in #0..#9. Cal

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5.5 CONFIG MODEM MENU Item Name Command Description Speed AT%Bn Set modem speed and protocol. V34 A

CHAPTER 3 : FRONT PANEL AND MENU TREE LL TX Level ATS30=n Set leased line transmit level. 0..-31 dBm /-13dBm (default) DL TX Level ATS56 =n

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5.6 CONFIG DTE MENU Item Name Command Description DTE Speed 300 bps 600 bps 1200 bps 1800 bps 2400 bps 3600

CHAPTER 3 : FRONT PANEL AND MENU TREE Disconnect AT&D2 /Disconnect. Normally used with 108.1. MODEM Reset AT&D3 /Force Modem reset. DSR

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5.7 COMMAND MENU Item Name Command Description Command Mode ATS19=n Intelligent function command set select

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5.8 LINE SETUP MENU Item Name Command Description Line Type AT&Ln Select line type and also set dial b

CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5.9 PROFILE MENU Item Name Command Description LOAD ATZn (n=0-9) This machine provides 20 groups of load co

INFORMATION TO THE USER NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device. Pursuant to Part 1

CHAPTER 3 : FRONT PANEL AND MENU TREE profile#0,and flush the stored telephone numbers. Are you sure??? /confirm the initializing action. Press e

CHAPTER 4: GENERAL INFORMATION AND FEATURES CHAPTER 4GENERAL INFORMATION AND FEATURES CONTENT 4.1 Preview 4.2 Dieal Line VS. Leased Line 4.3 2W/4

CHAPTER 4: GENERAL INFORMATION AND FEATURES CHAPTER 4: GENERAL INFORMATION AND FEATURES 4.1 Preview In order to help you to get familiar with you

CHAPTER 4: GENERAL INFORMATION AND FEATURES 4.3 2W/4W Leased Line We had talked modem operate in the previous section. There are two-wire leased li

CHAPTER 4: GENERAL INFORMATION AND FEATURES 4.5 Synchronous VS. Asynchronous The data formats of both connecting modems must be exactly the same in

CHAPTER 4: GENERAL INFORMATION AND FEATURES 4.7 Configuration Profile Set-Up The Network Series Modem have various operating modes. To save your e

CHAPTER 4: GENERAL INFORMATION AND FEATURES 4.10 Auto Dial Back-Up When you apply the modem to leased lines, no matter what protocol you are using,

CHAPTER 4: GENERAL INFORMATION AND FEATURES 7. Phase jitter P J = 1 Degree 8. Far-end echo level F Echo = -40 dB 9. Terminal mode DTE = 19200 A

CHAPTER 4: GENERAL INFORMATION AND FEATURES 4.16 ITU-T V.13/ V.23 Simulated Carrier Control in Half Duplex The modem normally operates in full dupl

FCC REQUIREMENTS This equipment complies with Part 68 of the FCC Rules. On the base unit of this equipment is a label that contains, among other in

CHAPTER 4: GENERAL INFORMATION AND FEATURES e. Dynamic Password/Call Back Control Code as “>”, “ <” will not take effect during Login check (w

CHAPTER 5 : INSTRUCTION SETS CHAPTER 5INSTRUCTION SETS CONTENT 5.1 AT Command Set 5.2 Dial Modifiers 5.3 Result Codes 5.4 V.25bis Auto C

CHAPTER 5 : INSTRUCTION SETS CHAPTER 5 : INSTRUCTION SETS 5.1 AT Command Set Table 5-1: AT Command Set Cmd Function Description A/ repeat th

CHAPTER 5 : INSTRUCTION SETS Cmd Function Description ATQn response on/off 0 : response on 1 : response off ATS S register read/write ATSnn? :

CHAPTER 5 : INSTRUCTION SETS Cmd Function Description AT&Gn guard tone options 0 : disabled 1 : 550 Hz 2 : 1800 Hz AT&Kn or AT\Qn DTE flo

CHAPTER 5 : INSTRUCTION SETS Cmd Function Description AT&Yn powerup user profile n (n=0~9) 0 : load user profile 0 on power up n : load user

CHAPTER 5 : INSTRUCTION SETS Cmd Function Description AT%Bn modem speed 0 : V.34_Adaptive 1 : V21_300 / FAX 300 2 : B103_300 3 : V22_1200 4 : B212

CHAPTER 5 : INSTRUCTION SETS Cmd Function Description AT%Dn DTR off-to-on actions 0 : DTR off-to-on normal (108.2) 1 : DTR off-to-on dial/ans acc

CHAPTER 5 : INSTRUCTION SETS 5.2 Dial Modifiers Table 5-2 Dial Modifiers for AT and V25bis command CODE Function Description 'T' or &a

CHAPTER 5 : INSTRUCTION SETS 5.3 Result Codes Table 5-3 AT Command Result Codes Short Long form 0 OK 1 CONNECT 2 RING 3 NO CARRIER 4 ERROR 5 CON

CHAPTER 1： MODEM INTRODUCTION Chapter 1MODEM INTRODUCTION 1.1 Description 1.2 Technical Specifications 1.3 Ordering Information 1

CHAPTER 5 : INSTRUCTION SETS Table 5-3 Result Codes (cont.) Short Long form 24 CONNECT 24000 25 CONNECT 26400 26 CONNECT 28800 27 CONNECT 32000 2

CHAPTER 5 : INSTRUCTION SETS 5.4 V.25bis Auto call Unit V.25bis auto call unit is used for auto calling in asynchronous and synchronous data forma

CHAPTER 6 : MAINTENANCE CHAPTER 6MAINTENANCE CONTENT 6.1 Description 6.2 Instruments 6.3 Periodic Maintenance 6.4 Troubleshooting 6.5

CHAPTER 6 : MAINTENANCE CHAPTER 6 : MAINTENANCE 6.1 Description This chapter gives you the information of maintenance and the required instrum

APPENDIX 1: Modem S-REGISTER TABLE APPENDIX 1: Modem S-REGISTER TABLE No Default Unit Function Description S0 1 times Auto-answer Ring Count S1

APPENDIX 1: S-REGISTER TABLE bit 6 - reserved bit 7 *0 - ATA Answer 1 - ATD Originate S15 reserved S16 01000000 binary

APPENDIX 1: S-REGISTER TABLE S22 01110110 binary Bit Mapped Options bit 1,0 - speak volume 00 - low *01 - medium 10 -

APPENDIX 1: S-REGISTER TABLE 10 - reserved 11 - reserved bit 3,2 - reserved bit 7-4 - Login check 0000..1001 - #0..

APPENDIX 1: S-REGISTER TABLE 1 - front panel lock bit 6,5 00 - AT%G0 auto FB/FF disable *01 - AT%G1 auto FB/FF enable

APPENDIX 1: S-REGISTER TABLE S42 00000010 binary Bit Mapped Options bit 0 reserved bit 1 0 - receive power drop control off *

CHAPTER 1： MODEM INTRODUCTION CHAPTER 1： MODEM INTRODUCTION 1.1 Description • The Network Series Modem are high performance, synchronous and asynch

APPENDIX 1: S-REGISTER TABLE 10 - reserved 11 - reserved 13 - reserved 14 - reserved 15 - V32_4800 16 - V32

APPENDIX 1: S-REGISTER TABLE 01 - medium 11 - reserved S59 0 10 - Low bit 2 - reserved bit 3 Security password

APPENDIX 2: LCD MENU QUICK REFERENCE APPENDIX 2: LCD MENU QUICK REFERENCE Main ScreenVersion screen Version screenV34 Adapt V42bisD ANS StandbySN:

APPENDIX 3: LCD MENU QUICK REFERENCE APPENDIX 3: LCD MENU QUICK REFERENCE ↓= "ENTER” KEY↑ = "EXIT” KEY→=“>” KEY← =“<” KEYCard Selecti

CHAPTER 1： MODEM INTRODUCTION 1.2 Technical Specifications Modem fully complies with ITU-T recommendations V.34, V.32bis, V.32, V.22bis, V.22, V.2

CHAPTER 1： MODEM INTRODUCTION Table 1-1A : Modem operating mode (4 wires/2wires L-L or D-L) Operating Mode MOD. Carrier Symbol rate Constellation